4 Cylinders Fuel Injection Cleaner & Tester For All Cars
GDI is an advanced electromechanical product, which can clean and test injectors by simulating engine working conditions. It can also perform cleaning on the injectors and fuel supply system on vehicle.
1. Dismantle free cleaning
2. Uniformity/Sprayability test
3. Automaticlly Ultrasonic cleaning
4. Delicate appearance
5. Sealing test
6. Injecting flow test
7. The adaptors as per colors to use
8. The glass pipes replaced by strong plastic pipes,more convenience and saftey during transportation.
9. Built in ultrasonice tank,more compact and easy to clean
Installation :
1. All equipment are delivered with 3 pin electrical cable, use the ground connection for equipment and operator protection.
2. Verify that test liquid level at 2.5L or at least between the range of two red lines. For a new machine, please fill 2.0~ 2.5L testing liquid. Never fill up the tank at its maximum capacity.
3. Fill up the ultrasonic cleaning tank with the liquid for injector cleaning. Liquid level should not reach 3 cm below the tank edge, in order to avoid liquid overflow on device. Take special care not to drop liquid on the equipment when filling up or emptying the tank.
Specifications:
* Power supply: AC220V±10%, 50/60Hz; AC110V±10%, 50/60Hz.
* Input power: 250W;
* Ultrasonic cleaner power: 100W;
* Simulated RPM range: 10~9990rpm; step: 10rpm;
* Time range: 1~9999s;
* Pulse width: 0.5~25ms; step 0.1 ms;
* Fuel tank capacity: 3000ml;
* Dimensions: 500*500*670mm
* Weight: About 43kg
Feature:
* Ultrasonic cleaning: To perform simultaneous cleaning on several injectors and to remove the carbon deposits on the injector completely.
* Uniformity/Sprayability test: To test the uniformity of injecting amount of each injector, and to monitor the spraying status of each injector with the help of backlight. This test is also for reverse flush.
* Leakage test: To test the sealing and dribbling conditions of injectors under system pressure.
* Injecting flow test: To check the injecting amount of the injector in 15 seconds of constant injection.
* Auto. test: To test injectors by simulating different working conditions.
* On-vehicle cleaning: The unit is equipped with various adaptors and couplers that facilitate cleaning on the injectors on vehicle.
Notice!!!
1) Different test joints are required to test different types of fuel nozzles. This device only provides basic configuration, more configurations of the connector need to be purchased separately. 2) Due to the difference in internal structure, some types of GDI nozzles cannot be temporarily tested. 3) In addition to cleaning the fuel injection nozzle, the ultrasonic device can also clean the small size of fuel pump, spark plug, etc. Parts, but pay attention to choosing the right cleaning agent. 4) In order to improve the cleaning and test results, please connect compressed air when performing GDI nozzle test and set the air pressure to 6-8 bar 5) If an extension cord is required, a cord with a rated current equal to or greater than the rated current of the device should be used. The wire may overheat when the rated current is lower than the current of the device. 6) The test liquid is used for uniformity/sprayability test, leak test, sample volume test and automatic. test. Detergents are used to clean the combustion chamber. Ultrasonic use special injector cleaner (or equipment Included test liquid and detergent) for cleaning
Product Tags:
|
|
4 Cylinders Ultrasonic Fuel Injector Cleaner Machine 100W For All Cars Images
|
